Running NPM 10.6, NTA 3.11.0 here. My Top 10 Chart shows errors all the time like this:
If you zoom in on an interface you get this:
BUT.....
If you actually login to the switch and look at the interface it shows no errors!
gale-mdf-cs01v#sho int tenGigabitEthernet 1/2
TenGigabitEthernet1/2 is up, line protocol is up (connected)
Hardware is Ten Gigabit Ethernet Port, address is xxxxxxxxxxxxxxx
Description: GALE-GHS 10G
Internet address is 10.255.255.9/30
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Gb/s, link type is auto, media type is 10GBase-LR
input flow-control is on, output flow-control is on
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:01, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 4590
Queueing strategy: Class-based queueing
Output queue: 0/40 (size/max)
5 minute input rate 8817000 bits/sec, 3247 packets/sec
5 minute output rate 42555000 bits/sec, 5847 packets/sec
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
IPv6 L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
IPv6 L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
1484618029 packets input, 623094025439 bytes, 0 no buffer
Received 1447985 broadcasts (31718 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
2236553166 packets output, 1949854136819 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
gale-mdf-cs01v#
Any ideas?