Hi There.
I'm new to Thwack so forgive me if this is the incorrect way to go about looking for help on NTM.
I've used NTM on Cisco using CDP with absolutely no issues. I am now evaluating NTM using LLDP on D-Link devices and i am having a few issues. I'm pushing to get this purchased, but if I cannot get it sorted 100% I will not be able to justify the purchase.
The scenario I'm facing....
Sw1 and sw2 are plotted after a network discovery.
NTM adds two connections between the nodes (there is just one)
This is how its mapped on NTM
SW1 port 8 -> unknown
SW2 port 16 -> unknown
Ive also noticed that NTM is labeling these connections as an ether-channel albeit just 1 physical connection.
Attached word doc will make more sense.
Any advice would be appreciated