I am trying to configure ether channel between a Huawei 3300switch and a linux server. I found out that i needed to use lacp as it supports interoperability between different types of hosts. i followed huawei's guide for forming ether channel. However when i do the configuration the ethernet goes down and the device becomes unpingable.
On the Linux side, the configuration looks like this:
cat /etc/modprobe.d/bond.conf
alias bond0 bonding
cat /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
ONBOOT=yes
USERCTL=no
BOOTPROTO=none
NM_CONTROLLED="no"
IPADDR=10.76.161.135
PREFIX=21
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME="System bond0"
BONDING_OPTS="mode=4 miimon=100 lacp_rate=1"
cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE="eth0"
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no
cat /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE="eth1"
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no